its almost....

[Parker]

just a sticky 215... stock 4 bolt

[KA-T_240]

no, the rims. like width wise?

[zbrown]

Parker;210101 wrote:
welp, it gets a bit better grip with a 215 on it, i cant tell if there spinning or not.... dont know what i can fit on the stock phone dialer rims, maybe you know zac... hoping i can fit a 250 on the stockers

ha i have no idea, think they are 6.5's

just throw some 7" slicks on there, lol, they will hook, just be as unstable as a motherf*cker

Vid?, i know it didn't rain today............?!?

[Grr]

toolbags, im going to chat, and your car is slow parker

[Parker]

ummm.... 5.5

[Joel]

[Joel]

Better pics of welds and headers later today...

[Joel]

[91nbtsi]

Did you use flux core wire or what?

[Joel]

no, were attempting to penetrate a 1/4 inch flange with a 135 amp welder. why do you ask about flux core? what characteristics make it look like it was made with a flux core welder?

[Joel]

[zbrown]

turn down the wire speed just a hair and the spatter will disappear, or just trigger it

that is the perfect size welder to be doing what you are

what is that 3.5 or 4??

[KA-T_240]

^3inch

[Joel]

zbrown;211063 wrote:
turn down the wire speed just a hair and the spatter will disappear, or just trigger it

that is the perfect size welder to be doing what you are

what is that 3.5 or 4??

Zach, my wire couldn't go any lower(3.5/10) without getting continuous burnback. I know how to set a welder ...and It's 3 inch.

[zbrown]

Joel;211069 wrote:
I know how to set a welder ...

obviously.........

[fanaticrockford]

What model welder is that?
Looks like the one I'm looking at purchasing Lincoln sp135t

The welder is perfectly capable of the job but not with that tiny ass long extension cord.

[Parker]

the cord is bigger than it looks

[Rexwagon]

Looks good parker. Cant wait to see that thing in person

[Joel]

fanaticrockford;211076 wrote:
What model welder is that?
Looks like the one I'm looking at purchasing Lincoln sp135t

The welder is perfectly capable of the job but not with that tiny ass long extension cord.

lol, the manual says it will penetrate 3/16... so its not made for that. If either of you wanna come make better welds, your welcome to.

[fanaticrockford]

I'm a beginner welder and can tell you your much better then me Joel. I have been doing a lot of research especially with the Lincoln sp135 which that welder looks to be. So what welder is that?

All I'm saying is that your losing a lot of current with that long extension cord. It may be adequate gauge like parker says but where is it plugged into? I suppose to an outlet? How far away is the outlet from the fuse panel and with what gauge wire?

I can guarantee you if the welder was plugged directly into the fuse panel or to a outlet close by those welds would be better.