The ugly silver camaro
-
SPRINGS!
Up to this point, it had some boltons, headers and exhaust, lid, 4.10 gears and a PTC 4500 stall converter.
[video]http://youtu.be/iQfjyMpjBGw[/video]
It was a blast to drive but I had once again gathered a pile of parts. So....
Ported heads, milled to death. 238/246 cam, 13:1 compression, and E85. Shortly after I Also switched to a 3800 stall PTC converter, as with the new power the old 4500 turned into a 5500
Little idle vid
[video]http://youtu.be/kgPimwzuuaI[/video]Like this the car ran a 13.000@114 on the street tires at a street legal day. I literally was spinning clear through most of 2nd gear.
SO, i bought some drag radials, and new rims
With that being the one and only change, the car ran 11.4@120 and i wasnt even pushing it. Still using the LS1 intake which is the most restrictive model there is, and a less than optimal exhaust setup. There is more to be had
-
Though I could have done so much more with that setup, my stupidity and good deals got the best of me
Light K-member, 35# of weight savings and so much easier to work on
LS1 back on the floor once again!
These showed up out of nowhere?
Then this fell out of the sky
378" of forged LS3 bottom end. Running the same heads and cam as that is what I spec'd the cam for when I bought it. This is
Mahle 4.075 forged pistons
Scat 6.125" h-beam rods
stock crank
Good Ls2 style timing set
the 243 heads that I did some more porting on
Cometic 4.085x.040 head gaskets
EPS 238/246 .608" 111+3 cam
BTR dual springs, ti retainers
stock rockers with Comp trunion bearing upgradeIt works out to be 14.15:1 compression, and around 10.55:1 dynamic compression. This will be backed up with a FLT trans stage 5 4l60e with all the good parts, and around a 5000 stall converter
-
Well sheesh, we run the same size injectors then...
(okay, so I only run 4 of them...)Looking great Gary, I hope I get to see it run next summer!
-
So this is the harness, it sucked big time to do, but it looks so much better. all done up in heat sleeving an no more corrugated plastic loom, god i hate that shit. I need to pick up a couple parts since I broke 2 of the small metal injector terminals. But its basically done and as good as I could get it. Think I have about $45 in heat shrink in this and have enough left to do a good amount of the engine bay harness as well. Wasnt planning on it but in the back of my mind I could hear Jim telling me "that wiring is fucking garbage" and I didnt want to go through that hours long teasing session
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login