New project

[z31]

Looks good. :icon_cheers: Did you make the oil pan?

[Cobra Rob]

As a trained welder you guys look like you know what you are doing

[XJHEAD]

z31;274684 wrote:
Looks good. :icon_cheers: Did you make the oil pan?

I made it black.. It is a Canton piece "of shit". Another thing that takes a hammer to make fit. Any manufacturer that says bolt-on is a liar.

Cobra Rob;274689 wrote:
As a trained welder you guys look like you know what you are doing

One of us maybe, and it's not me.

[z31]

You going to put your car in the all Ford car show at the track?

[XJHEAD]

z31;274695 wrote:
You going to put your car in the all Ford car show at the track?

I was planning on it. Even if not running but it is rollable, I will take it over there.

[63vette]

XJHEAD;274697 wrote:
I was planning on it. Even if not running but it is rollable, I will take it over there.
Pretty common for Fords to be pushed to car shows. Bong!!!!!

[63vette]

XJHEAD;274693 wrote:
One of us maybe, and it's not me.

I can weld aluminum between 3 and 5 beers. Any less or any more and I cant. :icon_scratch::icon_scratch::icon_scratch:

[Grr]

im in the same boat, i shake too much to weld alum properly unless i have a couple beers first, lol

[XJHEAD]

Before I put the intake on I figured it was a good idea to port match it. I took about an 1/8" off two sides of each port. Should have done that along time ago. Had to trim the gaskets too. Wrapped headers last night and tonight. Pulled turbos apart to check them out and cleaned them up.

[Cobra Rob]

as a mustang lover this is very sick keep up the good work

[z31]

That intake elbow going to clear the hood? :icon_scratch:

[z31]

What kinda power will that motor make without the turbos?

[XJHEAD]

z31;274970 wrote:
That intake elbow going to clear the hood? :icon_scratch:

Hope so, if not I'll get the chop saw out.

z31;274971 wrote:
What kinda power will that motor make without the turbos?

When it was N/A it did 485 rwhp @ 6,000

[Trafik Jamz]

Looks exactly like it did last time I saw it Bill...

of course that was 30mins before you posted these

[Grr]

z31;274970 wrote:
That intake elbow going to clear the hood? :icon_scratch:

just be sure to latch the hood when you take it out for the first time, wouldnt want any accidents like some people that will remain nameless......

[XJHEAD]

Motor is in.

[DaveH]

XJHEAD;275637 wrote:
Motor is in.

Thats a whole lotta orange around the engine. Looks good in there.:icon_cherry:

[weshole]

XJHEAD;275637 wrote:
Motor is in.

That's funny. All I see is an engine.

[XJHEAD]

weshole;275649 wrote:
That's funny. All I see is an engine.

Sorry about that, I meant the motor for the waterpump. That's the black part attached to the blue thing on the front of the engine.

[zbrown]

that engine plate looks nice